Texecom Premier 8XP-W - Premier SmartKey Features; LED Indications; PA Activation and Auxiliary Functions; Alarm Status and Arm Fail Indications

Premier 8XP-W & 32XP-W Installation Manual
35
Premier SmartKey™
LED Indications
Premier SmartKey™ Status LED
The Status LED has four colours. This LED cannot be disabled.
1. Pink = Power Up or Down
2. Green = Successful communication with the system
3. Flashing Blue = communication with system.
4. Red = Out of Range
5. Turquoise = Function Mode
POWER
FUNC TION 1/PC Control 1
FUNC TION 3/PC Control 3
FUNC TION 2/PC Control 2
Function S tatus L E D’s
Premier SmartKey s ta tus L E D
FUNCTION 3
FUNCTION 2
FUNCTION 1
 on Premier 412 816 & 832 Function 1 is the Arm Button and Function 2 is the Disarm button.
PA Activation
By default PA activation is enabled on the Premier SmartKey™, however the control panel should
be programmed to enable Radio PA. Please refer to your Control Panel manual for details.
Enable/Disable Alarm Status LED’s
The Alarm Status LED’s can be enabled or disabled either from the Engineers Keypad see page 27,
or RICOCHET™ Monitor.
 Alarm Status LED’s are not available on the Legacy Premier 412, 816 & 832. For legacy Premier
24/48/88/168 & 640 please see page 13 to programme the output functions required to enable
the LED indications.