Texecom Speech Dialler - Sending and Abort Options

Speech Dialler Operators Manual
INS233 13
Sending and Abort Options
Sending Options
Each input can be programmed to send a message to specific contacts, e.g., Input 1
could be programmed to send message 1 to all eight contacts, whereas Input 2 could
be programmed to send message 2 to contacts 2 and 7.
Call Abort
When a call is aborted the Speech Dialler immediately hangs-up and returns to its
normal standby mode. Each trigger input can be programmed to one of the following
options:
1 Nothing: The selected trigger input cannot be aborted.
2 Passcode Only: The selected trigger input can only be aborted by entering the
operators passcode into the Speech Dialler.
3 Code or Restore: The selected trigger input can be aborted by either entering
the operators passcode into the Speech Dialler or by restoring the trigger input to
its normal healthy condition.
4 Restore Only: The selected trigger input can only be aborted by restoring the
trigger input to its normal healthy condition.
! To Change the Sending and Abort Options:
1
From the main menu press ) or . to
select the Sending Options menu:
()*'+,'-./.0+12'
-.4=64:'>?+6,47'
2
Press ! to select:
E4?A+'K'-.4=7'+,'
3,4+50+'KHHHHHHH
3
Press ) to select the required input:
E4?A+'R'-.4=7'+,'
3,4+50+'HRHHHHHH'
4
Press + - 2 to toggle the Contacts, e.g.,
+-.. The top line will display the
contact name as each key is pressed:
E4?A+'R'-.4=7'+,'
3,4+50+'KRNSHHHH'
5
Press ! to select the next option:
E4?A+'K'$a,C+'`V'
L,+_64:'
6
Press # to change option, e.g., ##:
E4?A+'K'$a,C+'`V'
3,=.',C'".7+,C.'