Speech Dialler Operators Manual
INS233 19
5 Call Failed: This output type activates when the Speech Dialler fails to deliver its
message. The output deactivates when the unit is next triggered.
6 Remote Ctrl 1: This output type can be remotely turned on and off by a touch-
tone telephone.
7 Remote Ctrl 2: This output type can be remotely turned on and off by a touch-
tone telephone.
8 Memo Waiting: This output type activates when the Speech Dialler has a memo
waiting and deactivates once the memo has been played.
9 Memo Waiting (P): This output type pulses on and off when the Speech Dialler
has a memo waiting and deactivates once the memo has been played.
10 Remote Access: This output activates when the Speech Dialler is being
accessed remotely with a touch-tone telephone.
! To Program Outputs 1 and 2:
1
From the main menu press ) or 1 to
select the Output Options menu:
()*'+,'-./.0+12'
>A+?A+'>?+6,47'
2
Press ! to select:
>A+?A+'K'
F_,4.'@64.'^5A/+
3
Use ) or press + - , to select the
required output, e.g.
,:
>A+?A+'R'
35//'-A00.77BA/
4
Press # to change the output type, e.g.,
##:
>A+?A+'R'
".G,+.'3+C/'K'
5
Repeat steps 3 and 4 for the other output or
press
* to exit this menu.
Configuration Options
This section covers the various setup and configuration options:
Passcode
The Speech Dialler is protected by a 4 digit operator’s passcode; the passcode must
be used to gain access to the programming menus. The operator’s passcode is also
used for aborting calls and maybe required when using the Remote Access feature.
To Next Page
Loading...
Need help?
General
