Speech Dialler Operators Manual
INS233 27
Using the Remote Access Feature
The Remote Access feature can by accessed by one of the following methods:
Dial in for Remote Access
This method requires you to call into the Speech Dialler in order to select the Remote
Access menu. If the “Rem. Access Code” option is enabled (see page 23) you will
need to enter the operator’s passcode in order to use the Remote Access menu.
! To Dial in for Remote Access (Answer Defeat OFF):
1
Dial the Speech Dialler using a touch-tone telephone.
2
The Speech Dialler will answer your call after the programmed number of
rings (see page 21).
3
You will hear a series of high pitched beeps, press the [*] key on your
telephone whilst the beeps are playing. You will hear a short beep.
4
If required, enter the operator’s passcode on your telephone, you will
hear an acceptance tone. The Remote Access menu is now selected; see
the Remote Access menu on next page.
! To Dial in for Remote Access (Answer Defeat ON):
1
Dial the Speech Dialler using a touch-tone telephone.
2
Allow the telephone line to ring two or three times then hang up the call.
3
Wait approximately 10 seconds then redial the Speech Dialler.
4
The Speech Dialler will answer your call after the first ring.
5
You will hear a series of high pitched beeps, press the [*] key on your
telephone whilst the beeps are playing. You will hear a short beep.
6
If required, enter the operator’s passcode on your telephone, you will
hear an acceptance tone. The Remote Access menu is now selected; see
the Remote Access menu on next page.
To Next Page
Loading...
Need help?
General
