Speech Dialler Operators Manual
28 INS233
Acknowledge Call and Select Remote Access Mode
If the Speech Dialler has been triggered and is reporting a voice message to a
contact, the contact can (if programmed, see page 9) acknowledge the call and select
the Remote Access mode.
! To Acknowledge a Call and Select Remote Access Mode:
1
When the telephone rings, answer the call as normal.
2
Listen to the voice message. The message is repeated 10 times in total.
3
When you have understood the message acknowledge it at any time by
pressing the [*] key on your telephone. You will hear an
acknowledgment tone from the Speech Dialler and then the unit will
automatically select the Remote Access menu, see the Remote Access
menu below.
The Remote Access Menu
The following commands can be selected from the Remote Access menu:
Function Key Sequence
Toggle Remote Control Output 1 [*][1]
Toggle Remote Control Output 2 [*][2]
Listen-in/Talkback Mode [*][3] to select [3] to toggle
Play Voice Messages 1 – 4 [9] followed by [1] - [4]
Record Voice Messages 1 – 4 [*][9] followed by [1] - [4]
Playback Memo [0]
Record Memo [*][0]
Stop Recording/Playback [0] or any key
Quit Remote Access Menu and Hang-up [#]
If after 30 seconds no command has been selected then Speech Dialler will
hang-up the call. Once a command has been selected the unit remains
online for 3 minutes or until the quit remote access command is used (#).
To Next Page
Loading...
Need help?
General
