Speech Dialler Operators Manual
INS233 29
Toggle Remote Control Outputs
This Remote Access command allows you to either switch on or off the remote control
outputs.
! To Toggle the Remote Control Outputs:
1
Establish a Remote Access connection with the Speech Dialler.
2
Press [*] [1] on your telephone to toggle Remote Control Output 1 or [*]
[2] to toggle Remote Control Output 2. You will hear one high pitched
beep when Output 1 is switched on and two for Output 2. You will hear
one low pitched beep when Output 1 is switched off and two for Output 2.
3
Use your telephone to select other Remote Access commands or press
[#] to hang-up the connection with the Speech Dialler.
Listen-in & Talkback Mode
These Remote Access commands allow you to listen-in and talk to the remote site
using your telephone handset.
! To Select Listen-in/Talkback Mode:
1
Establish a Remote Access connection with the Speech Dialler.
2
Press [*][3] on your telephone. You can now listen into the premises.
3
Press [3] on your telephone to switch between the Listen-in and Talkback
mode. The Listen-in/Talkback mode can also be toggled at site by
pressing
*.
4
When finished press [0] on your telephone to cancel Talkback mode.
5
Use your telephone to select other Remote Access commands or press
[#] to hang-up the connection with the Speech Dialler.
To Next Page
Loading...
Need help?
General
