Speech Dialler Operators Manual
8 INS233
Contact Details
The Speech Dialler can store up to 8 contacts; each contact is assigned the following
parameters:
Name
Up to 16 characters can be assigned to the contact name.
Telephone No.
The contact’s telephone number (up to 24 digits). When programming the contact’s
telephone number the $ key can be used to insert the following command
characters:
H Star: Inserts a * in the telephone number.
I Hash: Inserts a # in the telephone number.
J Pause: If the unit is connected to an internal telephone system you normally have
to dial a number to get an external line wait a couple of seconds then dial the
actual number. The pause command can be used to insert a 3 second delay,
e.g., 9,0161 123456.
Contact Type
The contact type can be programmed to one of the following options:
1 Voice Only: The Speech Dialler dials the contact telephone number and plays
the relevant voice message.
2 Voice or Text: The Speech Dialler dials the contact’s telephone number and
plays the relevant voice message. If the voice message is not acknowledged by
the contact the Speech Dialler dials the SMS service centre and attempts to relay
the relevant text message to the contact’s telephone number.
3 Text or Voice: The Speech Dialler dials the SMS service centre and attempts to
relay the relevant text message to the contact’s telephone number. If the SMS
service centre is busy the Speech Dialler dials the contact’s telephone number
and plays the relevant voice message.
4 Text Only: The Speech Dialler dials the SMS service centre and relays the
relevant text message to the contact’s telephone number.
Contact types 2, 3 & 4 should only be used for mobile telephone numbers.
To Next Page
Loading...
Need help?
General
