Texecom Speech Dialler - Page 20

Speech Dialler Operators Manual
20 INS233
! To Change the Operators Passcode:
1
From the main menu press ) or 2 to
select the Configuration menu:
()*'+,'-./.0+12'
3,4B6:AC5+6,4'
2
Press ! to select:
()*'+,'-./.0+12'
F5770,=.
3
Press ! to select:
>@%'3>%#M'KRNS'
L#]'3>%#M'KRNS
4
Enter the new passcode, e.g., /0
12:
>@%'3>%#M'KRNS'
L#]'3>%#M'TQUe'
5
Press ! to accept. Press * to exit this
menu.
Dialling Options
The following dialing options are available:
1 Blind Dialling: If enabled (`) the Speech Dialler will not wait for dial tone when
dialling out. If disabled (H) the Speech Dialler will wait for dial tone before dialling
the contact’s telephone number.
2 Pulse Dialling: If enabled (F) the Speech Dialler will use the older pulse format
when dialling out. If disabled (H) the Speech Dialler will use DTMF format when
dialling out.
3 Pulse After 3: If enabled (N) the Speech Dialler will switch to the older pulse
format when the unit has failed to communicate after 3 attempts. If disabled (H)
the Speech Dialler will always use DTMF format when dialling out.
4 Use 7,E,1 Data: If enabled (U) the Speech Dialler will communicate with the SMS
service centre using 7 data bits, even parity and 1 stop bit. If disabled (H) the
Speech Dialler will communicate with the SMS service centre using 8 data bits,
no parity and 1 stop. See page 22 for further details.
! To Change the Dialling Options:
1
From the main menu press ) or 2 to
select the Configuration menu:
()*'+,'-./.0+12'
3,4B6:AC5+6,4'