Thermal Dynamics CUTMASTER 39 User Manual

cutmaster 39
OPERATION 4-4 Manual 0-4976
D. Gas Selection
Ensure gas source meets requirements (refer to Section 2). Check connections and turn gas supply on.
E. Connect Work Cable
Clamp the work cable to the workpiece or cutting table. The area must be free from oil, paint and rust. Connect
only to the main part of the workpiece; do not connect to the part to be cut off.
Art # A-03387
F. Power On
Place the Power Supply ON / OFF switch to the ON (up) position. AC indicator turns on.
A-07932
A
3020
26
28
24
22

Thermal Dynamics CUTMASTER 39 Specifications

General

Brand	Thermal Dynamics
Model	CUTMASTER 39
Category	Welding System
Language	English