Thermal Dynamics CutMaster 58 User Manual

CUTMASTER 58
Manual 0-5544 INTRODUCTION
2-1
SECTION 2 SYSTEM:
INTRODUCTION
2.01 How To Use This Manual
This Owner’s Manual applies to Thermal Dynamics® and ESAB
CutMaster 58 systems
To ensure safe operation, read the entire manual, including
the chapter on safety instructions and warnings.
Throughout this manual, the words WARNING, CAUTION, and
NOTE may appear. Pay particular attention to the information
provided under these headings. These special annotations
are easily recognized as follows:
NOTE!
An operation, procedure, or background information
which requires additional emphasis or is helpful in
ecient operation of the system.
!
CAUTION
A procedure which, if not properly followed, may
cause damage to the equipment.
!
WARNING
A procedure which, if not properly followed, may
cause injury to the operator or others in the operat-
ing area.
WARNING
Gives information regarding possible electrical
shock injury. Warnings will be enclosed in a box
such as this.
Additional copies of this manual may be purchased by
contacting Thermal Dynamics at the address and phone
number in your area listed on back cover of this manual.
Include the Operating Manual number and equipment
identication numbers.
Electronic copies of this manual can also be downloaded at
no charge in Acrobat PDF format by going to the ESAB web
site listed below and clicking on "Product Support" / "ESAB
Documentation": / "Download Library", then navigate to
"Plasma Equipment" and then "Manual".
http://www.esab.com
2.02 Equipment Identification
The unit’s identification number (specification or part
number), model, and serial number usually appear on a
data tag attached to the bottom. Equipment which does
not have a data tag such as torch and cable assemblies are
identied only by the specication or part number printed
on loosely attached card or the shipping container. Record
these numbers on the bottom of page i for future reference.
2.03 Receipt Of Equipment
When you receive the equipment, check it against the invoice
to make sure it is complete and inspect the equipment for
possible damage due to shipping. If there is any damage,
notify the carrier immediately to le a claim. Furnish com-
plete information concerning damage claims or shipping
errors to the location in your area listed in the inside back
cover of this manual.
Include all equipment identication numbers as described
above along with a full description of the parts in error.
Move the equipment to the installation site before un-crating
the unit. Use care to avoid damaging the equipment when
using bars, hammers, etc., to un-crate the unit.

Thermal Dynamics CutMaster 58 Specifications

General

Brand	Thermal Dynamics
Model	CutMaster 58
Category	Welding System
Language	English