INTRODUCTION & DESCRIPTION 2 Manual 0-2577
1.2 SYSTEM OPTIONS AND TORCH PARTS
System Options
Torch Parts Selection
These items can be used to customize a standard system for a
particular application or to further enhance performance.
• High Pressure Regulators - Available for air and Nitrogen (N
2
).
• Cutting Guide - This device provides precise cutting capability
with a hand torch. The guide fits 70° and 90° hand torches. The
kit includes roller guides and pivots that attach to the torch.
• The Leads Storage Kit (Catalog # 7-0253) - Provides a place to
store the EMC Pak Master 25 Torch Leads and is designed to
be mounted on the top of the Pak Master 25 EMC Model Power
Supply.
• Air Line Filter - Removes damaging contaminants and mois-
ture from the air stream when using compressed air.
Recommended Air Filter Assembly
Single Stage Inline Kit ................................... Cat. No. 7-0250
Replacement Cartridge*................................ Cat. No. 7-0251
The same torch parts are used for drag cutting and standoff
cutting. See Section 4.5, Replacing Consumable Torch Parts.
Order replacement parts by catalog number and description.
Address inquiries to your authorized Thermal Dynamics dis-
tributor.
Standard Shield Cup
Catalog No. 9-6003
Standard Cutting Tip
Catalog No. 9-4476
Electrode
Catalog No. 9-6006
Gas Distributor
Catalog No. 9-6007
A-00778
To Next Page
Loading...
Need help?
General
