Thermal Dynamics ULTRA-CUT 100 User Manual

WARNINGS
Read and understand this entire Manual and your employer’s safety practices before
installing, operating, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best judge-
ment, the Manufacturer assumes no liability for its use.
Plasma Cutting Power Supply, Ultra-Cut
®
300
Operting Manual No. 0-4819
Published by:
Thermadyne Corporation
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
www.thermal-dynamics.com
© Copyright 2005,2006,2007 by
Thermadyne Corporation
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of the
publisher is prohibited.
The publisher does not assume and hereby disclaims any liability to any party for
any loss or damage caused by any error or omission in this Manual, whether
such error results from negligence, accident, or any other cause.
Printed in the United States of America
Licensed under U. S. Patent No. 5,070,227
Publication Date: July 10, 2007
Record the following information for Warranty purposes:
Where Purchased: ___________________________________
Purchase Date:______________________________________
Power Supply Serial #:_______________________________
Torch Serial #:_______________________________________

Thermal Dynamics ULTRA-CUT 100 Specifications

General

Brand	Thermal Dynamics
Model	ULTRA-CUT 100
Category	Welding System
Language	English