THK TSC Series - System Configuration; System Configuration Diagram

1-6
1. Introduction
TSC
3-1
System configuration diagram
⿟
The diagram below shows a representative example for using the economy series ES with the
driver controller TSC.
⿟
Cables used for connecting the devices shown with
★
should be prepared by yourself.
3.
System configuration
TDO
(→*1)
PC (D-STEP) (
→
*2)
Higher device
Emergency stop switch
(This should be pre-
pared by yourself. )
(→P.3-12)
Driver controller
TSC
The actuator cable is provided
with the actuator unit.
(
→
*3)
* To use a 10m actuator cable,
please insert a noise filter.
Recommended noise filter is
“RSAN-2003 (made by TDK-
Lambda Corporation)”.
24V DC power
★
★
★
Power supply should be pre-
pared by yourself. Power con-
nector is provided with TSC.
(
→
P.3-4)
CN1
CN2
CN4
CN3
CN5
Actuator
PC communication
cables are provid-
ed as an option.
(→P.2-5)
★
I/O connector for CN1 is
provided with TSC.
I/O cables are provided
as an option.
(
→
P.2-5)
★
*1: See the separate TDO Instruction Manual.
*2: See the separate D-STEP instruction manual.
*3: See the separate ES/EC instruction manual.