4-9
3.
Function mode 1
4. TSC Functions
TSC
3-7
Timing chart (Instruction mode)
In the instruction mode (MODE (pin.9) is ON), STRT/PWRT (pin.13) serves as PWRT.
Write the current position data into the "Position (mm)" field of the program table.
Writing is executed by turning ON the current position writing signal STRT/PWRT (pin.13) for 20
ms or more in the instruction mode (MODE (pin.9) input is ON).
Once writing is completed, the writing completion signal WEND (pin.31) turns ON for 30 ms.
External input instruction mode input "MODE"
External instruction mode selection
Position number selection
JOG/INCHING selection
During JOG/INCHING operation
Moving direction +
Moving direction -
Instruction position number input"P10 to P15"
Manual switching input "JOG/INCHING" during external input instruction
Moving direction + input "JOG P" during external input instruction
Moving direction - input "JOG N" during external input instruction
Current position writing input "PWRT" during external input instruction
Writing completed output "WEND"
ON: INCHING
OFF: JOG
To Next Page
Loading...