THK TSC Series - Area Determination

10.
Area determination
5-15
5. Operations and
adjustment
TSC
10-1
Area determination
⿟
There are 2 types: "area determination" that sets the determination range by parameters and "P
area determination" that sets for STEP No. of the program table.
⿟
When the actuator enters into the range set by the parameter No.1 (Max. area) (
→
P.5-19) and
No.2 (Min. area) (
→
P.5-19), AREA output (pin.26) is turned ON (, which is executable in function
modes 0, 4 and 5).
⿟
AREA output (pin.26) will also be output during job and inching operations.
⿟
When the actuator enters into the range configured in the "P area A (mm)" and "P area B (mm)"
of the "program table", the P AREA output (pin.27) turns ON (, which is executable in operation
modes 0, 1, 2, 4 and 5).
* The P area set for the running STEP No. is valid. The P area for other STEP No. is invalid.
⿟
For more information on settings, see the separate D-STEP or TDO Instruction Manual.
No. Parameter name Set value
1 Max. area 100.00
2 Min. area 40.00
Area output signal "AREA"
P area output signal "P AREA"
80mm/s
30mm/s
STEP No.0
STEP No.1
50
60
90 11010040
Position
[mm]
Speed
STEP No. ABS / INC
Position Speed P area A P area B JUMP
Comment
[mm] [mm/s] [mm] [mm] [No.]
0 ABS 60.00 80 50.00 70.00 1 STEP No.0 operation (green)
1 ABS 120.00 30 90.00 110.00 E STEP No.1 operation (blue)
* Some of the setting fields are omitted.