THK TSC Series - Pause

5.
Pause
5-10
5. Operations and
adjustment
TSC
5-1
Pause
⿟
Turning the PAUSE input (pin.16) OFF during operations will decelerate the speed and then
pause it. Turning ON will resume the operations for the remaining move amount for the STEP No.
that was active before turning the PAUSE input (pin.16) OFF.
⿟
During pause, turning ON the REST input (pin.17) will cancel the remaining move amount for the
STEP No. that was active before turning the PAUSE input (pin.16) OFF. In this case, turning ON
the PAUSE again will not resume the operations and the unit remains in the position, so enter the
operation command for the next STEP No.
* The operation command of the next STEP No. should be the STEP No. other than the one that
was active before turning the PAUSE input (pin.16) OFF.
The same STEP No. was canceled with the REST input, so its operation command cannot be
accepted.
⿟
When "Invalid" is selected for the parameter No.33 (Selection of invalid for pause input) (
→
P.5-24),
pause is invalid regardless of ON/OFF status of the PAUSE input (pin.16). (it does not pause.)