14.
Parameters
5-19
5. Operations and
adjustment
TSC
14-1
Parameter: Actuator information
You can set and save the following items for the parameters:
①
Basic operations/constants of the driver controller/actuator.
②
Initial values entered into program table.
③
Constants related to servo operations.
For actual setup operations, use the setup tool D-STEP or the digital operator
TDO. For more information, see the separate instruction manual.
Depending on the function mode, some parameters do not function.
Example) "Max. area" and "Min. area" of the function mode 1
←
Due to the lack of
area output.
There are some missing numbers or non-disclosed parameters due to circum-
stances.
14-2
Parameter: Actuator operation settings
No. Parameter name Unit Setting range Default value
7
Push judgment time ms 1 to 99999 100
Description
Sets the time from when the actuator hits a work in the pressing operation until when the
operation is judged to be completed.
8
Default speed mm/s 1 to 1000 100
Description
Inputs the default value of "Speed" entered when double-clicking an arbitrary row of the
program table.
9
Default ACCEL/DECEL m/s
2
1 to 100 3
Description
Inputs the default value of "ACC" and "DCC" entered when double-clicking an arbitrary
row of the program table.
10
IN-POSI range mm 0.00 to 999.99 0.02
Description
Inputs the default value of "Positioning width" entered when double-clicking an arbitrary
row of the program table.
No. Parameter name Unit Setting range Default value
1
Max. area mm -9999.99 to 9999.99 9999.99
Description Sets the + side (MAX side) of the area where the AREA signal (pin.26) turns ON.
2
Min. area mm -9999.99 to 9999.99 -9999.99
Description Sets the - side (MIN side) of the area where the AREA signal (pin.26) turns ON.
3
Soft limit + mm 0.00 to 9999.99 9999.99
Description Sets the + side (MAX side) of the actuator-movable area.
4
Soft limit - mm -9999.99 to 0.00 -9999.99
Description Sets the - side (MIN side) of the actuator-movable area.
6
ORG offset mm -9999.99 to 9999.99 0.00
Description Enables the zero point of absolute coordinate system to be set in an arbitrary position.
To Next Page
Loading...