3-14
2.
External input and output (CN1)
3. Wiring
TSC
2-1-2
External output specifications
2-1-3
Filter for noise reduction
An input-time constant is set in order to prevent malfunctions due to chattering and noises of the in-
put signals, etc.
The input signal is switched when the same state continues for 6 ms or longer (ON
→
OFF and
OFF
→
ON).
Items Specifications
Rated load voltage 24 VDC ± 10%
Maximum current 50 mA/1 circuit
Residual voltage 0.3 V or less
Insulation method Photo coupler
RL
Internal circuit
External
power supply
24 VDC
0.01μF
Each output
TSC
1, 2
19 to 34
* In case of relay load,
be sure to connect
a diode for surge killer.
43, 44
2-1-4
Connector pin number
1
15
16
30
3144
* This figure shows the view from the fit surface with the plug.
To Next Page
Loading...