THK TSC Series - Page 62

5-1
5. Operations and adjustment
TSC
This section describes the
standstill mode details.
About this chapter
This chapter describes the operations and adjustment.
1.
Operation mode……………… 5-4
1-1. MANUAL mode ……………………………… 5-5
1-2. AUTO mode ………………………………… 5-5
1-3. MANUAL mode switching ………………… 5-5
2.
Stop mode …………………… 5-6
2-1. Invalid ………………………………………… 5-6
2-2. Auto servo OFF 1 (ASO 1) ………………… 5-6
2-3. Auto servo OFF 2 (ASO 2) ………………… 5-6
2-4. Auto servo OFF 3 (ASO 3) ………………… 5-6
2-5. Full servo control (SERVO) ……………… 5-7
3.
Servo ON ……………………… 5-8
3-1. Servo ON …………………………………… 5-8
4.
Zero return …………………… 5-9
4-1. Zero return method ………………………… 5-9
4-2. Positive/negative of moving direction … 5-9
5.
Pause ……………………… 5-10
5-1. Pause ………………………………………… 5-10
This section describes the
operation mode details.
This section describes the
servo ON details.
This section describes the
zero return details.
This section describes the
pause details.