2-31
8 Install the adapter fittings to the drive motor.
9 Install the brake lines to the drive motor. (fig. C3490)
10 Install the high pressure drive hoses. (fig. C3490)
11 Clean the final drive housing and inspection cover
thoroughly before applying silicone sealant. (fig. C3495)
12 Install the inspection cover. When installing the nuts,
do not over tighten. The mounting torque should not
exceed 11 lbs / ft. (15 N.m.)
14 Start the engine and check for hydraulic leaks. Do
not use your hands to trace hydraulic leaks. Shut off the
engine and inspect each fitting for proper torque.
15 Install the wheels and torque the nuts at 100 to 110
lbs / ft. (136 to 149 nm.)(fig. C3497)
16 Install shields and seat, let loader down to ground
and test drive to check performance.
DRIVE MOTOR 2.11
C3495
Clean sealing area
C3490
C3490
Brake hoses
Hi - pressure hoses
C3497
Torque the wheel nuts
Refer to the torque chart in Section 2.13 when tight-
ening hydraulic hoses and fittings
IMPORTANT
Inspect fitting o-rings and flares for marks or dam-
age. Replace if necessary.
IMPORTANT
WARNING
Use caution when dealing with hydraulic fluid under
pressure. Escaping fluid under pressure can pene-
trate the skin and cause serious injury.
WARNING
To prevent personal injury never make repairs to the
hydraulic system while the engine is operating.
To Next Page
Loading...
