- 1 -
TABLE OF CONTENTS
PRIOR TO STARTING ENGINE……………………………………………………………………….……………….………………….…………...8
REQUIRED SETTINGS FOR OPERATION
MANUAL OPERATION SETTINGS
AUTOMATIC OPERATION SETTINGS
MANUAL THROTTLE SETTINGS…………………………………………………………………………………………………...……………….10
STANDARD VERNIER UP AND DOWN THROTTLE
MULTISTATE THROTTLE
AUTOMATIC THROTTLE SETTINGS……………………………………………………………………………………….…………………….11
SINGLE SPEED (PROFILE) THROTTLE
LINEAR THROTTLE
LEVEL OR PRESSURE MAINTAIN THROTTLE
PANEL OPERATION…………….…………………………………………………………………………………….……………………………….……….17
MANUAL OPERATION
AUTO START/STOP OPERATION
SLEEP MODE
MODULE CONNECTORS…………………………………………………………………………………………………….……………………………..18
PRIMARY 14 PIN MODULE CONNECTOR
SECONDARY 23PIN CONNECTOR
PANEL CONNECTOR……...………………………………………………...……………………………………………….……………………..………….20
21 PIN ENGINE HARNESS CONNECTOR
31 PIN ACCESSORY CONNECTOR
ENGINE ALARMS, CODES AND MESSAGES………………………………………………………………………………........………...23
ENGINE ECU ALARMS/DE-RATE/SHUT DOWNS
PANEL ALARM ANNUNCIATION AND CODE READER
ALARM HORN SILENCE
PANEL INDICATION LAMPS
ACTIVE AND STORED ENGINE ECU CODES
CONTROL PANEL SPECIFIC ALARMS AND SHUT DOWNS…………………………………………….…………..……….25
CONTROL PANEL ANALOG AND DIGITAL INPUTS……………………….…...………………………………………………..…26
ANALOG INPUT FUNCTIONS
DIGITAL FUNCTIONS
CONTROL PANEL RELAY OUTPUTS ……………………………………………………………………..….…………………...................…..28
RELAY FUNCTIONS, POLARITY & INITIAL STATE
PANEL TO ENGINE ECU COMMUNICATIONS…..…………….……………………………………………………………….…….31
BATTERY RECHARGE MONITOR………………………………………….……………………………………………………………..….…....32
MODBUS CONFIGURATION………………………………………….……………………………………………………………………..….…....32
To Next Page
Loading...
