THOMPSON PUMP J1939 - Quick Setup; Engine Parameter Configuration; Pump Parameter Configuration; Scheduler Configuration

- 46 -
CONFIGURATION MENUS
(2)
Engine Parameter Configuration
Engine Type (Leave as Electronic, DO NOT CHANGE)
Parameter Selection (Speed, Coolant Temp., Oil Pressure, Fuel Level,
Voltage, Hour Meter)
Parameter Setup (Varies based on parameter)
(3)
Pump Parameter Configuration
Parameter Selection (Transducer, Inlet, Outlet Pressure, Flow Rate)
Parameter Setup (Varies based on parameter)
(4)
Scheduler Configuration
Clear Events (Yes, No)
Schedule Event (1-8)
Start Time
Stop Time
Day of Week (Off, All, Alternate, Mon, Tue, Wed, Thu, Fri, Sat, Sun)
(5)
Input Configuration
Configure Selection (Default = Channels, optional Custom Message)
Digital Input Selection 1-9
Digital Action Selection
Digital Message Selection
Digital Delay
Digital Polarity (NO, NC)
(6)
Output Configuration
Output Relay Selection 1-8
Relay Function Selection
Relay Polarity (Positive, Invert)
Relay Initial State
Relay Allow Power Down
(7)
Throttle Configuration
Throttle Type - Throttle Type Selection
TSC Mode Selection
TSC Min Speed Selection
TSC Max Speed Selection
TSC Bump Speed Selection
TSC Ramp Rate Selection
Throttle Curve Selection
Multistate Speed 1-4 Selection
(1)
Quick Setup
NOT TO BE USED FOR THIS CONTROLLER