THOMPSON PUMP J1939 - Control Panel Relay Outputs

- 26 -
CONTROL PANEL RELAY OUTPUTS
The panel provides relay outputs defined below located in the Output Configuration menu. The
relays are rated at 5 amps.
The panel is shipped from the factory with the highlighted outputs enabled and pre-
wired in the panel.
Relay
Heading
Default
Connector
Pin
Relay 1
Function
Start & Alarm Horn
31 Pin
Connector
17
Polarity
Positive
Initial State
Off
Relay 2
Function
Fuel/Run
21 Pin
Connector
G
Polarity
Positive
Initial State
On
Relay 3
Function
Alarm
31 Pin
Connector
3
Polarity
Positive
Initial State
Off
Relay 4
Function
Crank
21 Pin
Connector
D
Polarity
Positive
Initial State
Off
Relay 5
Function
High Level Alarm
31 Pin
Connector
1
Polarity
Positive
Initial State
Off
Relay 6
Function
Unit in Auto
31 Pin
Connector
16
Polarity
Positive
Initial State
On
Relay 7
Function
Over Crank (Fail to Start)
31 Pin
Connector
8
Polarity
Positive
Initial State
Off
Relay 8
Function
Engine Run
31 Pin
Connector
23
Polarity
Positive
Initial State
Off