THOMPSON PUMP J1939 - Module Configuration; Display Configuration; CAN Configuration; Auto Operation Settings

- 48 -
(10)
Module Configuration
Low Power Mode (Default = Auto Only)
Pre Alarms Displayed (Default = 3)
Clear Operation Log Yes/No
Clear Alarm Log Yes/No
Engine Run Criteria (Default = 400 rpm)
Engine Stop Criteria (Default = 50 rpm)
(11)
Display Configuration
Pressure & Temperature Units (Default = English)
Performance Display (Default = Off)
(12)
CAN Configuration
Engine Type (Default = John Deere)
TSC1 Address (Default = 3)
Source Address (Default = 44)
Engine Address (Default = 0)
Speed Transmit
Temperature Transmit
Oil Pressure Transmit
Fuel Level Transmit
Voltage Transmit
Hours Transmit
Pump Parameter Transmit
Fault Transmit
JDLINK Auto Accept (Default = Off)
(13)
Auto Operation Settings
Control Transducer (Default = Application)
Start/Stop Input (Floats, Transducer)
Menu options changed based on start/stop input selected