THOMPSON PUMP J1939 - Manual Throttle Settings; Vernier Throttle; Multistate Throttle

To Next Page

To Previous Page

- 5 -

MANUAL THROTTLE SETTINGS

The following bolded settings are required for manual throttle operation in the Throttle

Configuration menu.

VERNIER THROTTLE (DEFAULT)

Vernier throttle is standard up and down throttle between the minimum and maximum selections.

The ramp rate is the rate of acceleration in RPM’s per second. The control panel uses J1939 throttle,

also called “torque speed control” or TSC1.

Throttle Configuration Menu

Throttle Type - Throttle Type Selection (Default = Vernier)

TSC Mode Selection (Default=Primary)

TSC Min Speed Selection (Preset by pump specification)

TSC Max Speed Selection (Preset by pump specification)

TSC Bump Speed (Default = 20 rpm)

TSC Ramp Rate Selection (Default = 100 rpm/sec)

Throttle Curve Selection

Multistate Speed 1 Selection

Multistate Speed 2 Selection

Multistate Speed 3 Selection

Multistate Speed 4 Selection

TSC Absolute Minimum Speed (Preset to pump specification)

TSC Absolute Maximum Speed (Preset by pump specification)

MULTISTATE THROTTLE

Multistate throttle provides for one, two, three or four specific operating speeds. Pressing the up and

down buttons adjusts engine speed between the selected multistate speed selections.

Throttle Configuration Menu

Throttle Type - Throttle Type Selection (Select Multistate)

E-Throttle Mode Selection

TSC Mode Selection