THOMPSON PUMP J1939 - Engine Safety Configuration; Pump Safety Configuration

- 47 -
(8)
Engine Safety Configuration
Sender Check Bypass Time Period Selection
Fuel Level Check On/Off Selection
Low Fuel Level Pre Alarm % Selection
Low Fuel Level Alarm % Selection
Fuel Level Alarm Delay Time Selection
Oil Pressure Check On/Off Selection
Low Oil Pressure Pre Alarm % Selection
Low Oil Pressure Alarm % Selection
Oil Pressure Alarm Time Delay Selection
Engine Temperature Check On/Off
Engine Temperature Pre Alarm Selection
Engine Temperature Alarm Selection
Engine Temperature Alarm Time Delay Selection
Battery Volt Check On/Off
Low Battery Volt Pre Alarm Selection
High Battery Volt Pre Alarm Selection
Battery Volt Trim Setting
Over Speed Alarm On/Off
Over Speed Alarm RPM Setting
Over Speed Alarm Time Delay Selection
(9)
Pump Safety Configuration
Inlet Pressure Check (Default = Off)
Low Inlet Pressure Pre Alarm (Default = -14.7 psi)
Low Inlet Pressure Alarm (Default = -14.7 psi)
High Inlet Pressure Pre Alarm (Default = (25 psi)
High Inlet Pressure Alarm (Default = 25 psi)
Inlet Pressure Alarm Delay (Default = 0:05)
Inlet Pressure Hysteresis (Default = 5.0 psi)
Outlet Pressure Check (Default = Off)
Low Outlet Pressure Pre Alarm (Default = 0 psi)
Low Outlet Pressure Alarm (Default = 0 psi)
High Outlet Pressure Pre Alarm (Default = (300 psi)
High Outlet Pressure Alarm (Default = 300 psi)
Outlet Pressure Alarm Delay (Default = 0:05)
Outlet Pressure Hysteresis (Default = 5 psi)