P8
QUICK GUIDE TO USING YOUR RECEIVER
Channel No.: Select a channel that is known to carry a
broadcast in your region. The Signal Strength and
Signal Quality bars give a visual indication of the
reception. Adjust your antenna to obtain maximum
signal strength and quality.
Once all settings are made, press OK to start scanning.
The receiver will now search for all available channels. Once scanning is finished,
the receiver switches to viewing mode.
TIP: In case the Welcome “Easy install” menu does not appear after
switching on the receiver the first time, reset the receiver to factory
settings by pressing the MENU button and selecting Tools, then
submenu Load Factory Setting (Default PIN 0000)
5.0 QUICK GUIDE TO USING YOUR RECEIVER
We at THOMSON understand that you can’t wait to enjoy your new high definition
digital terrestrial receiver. The following quick guide will make you familiar with the
basic operation of this device. We do, however, advice you to read the full manual
to get the best performance from your receiver.
To turn your receiver ON or to Standby, use the q button on the remote control.
Choose the desired channel with the pq buttons. Alternatively, you can digit
the channel number with the 0~9 buttons on the remote control. Or press OK in
viewing mode to display the channel list. The volume can be adjusted with the
tu buttons.
6.0 OPERATION
Your new receiver is equipped with several features to make watching TV a true
pleasure. This paragraph describes these features. Please also read chapter 7.0 to
get familiar with the menu of your receiver.
6.1 Changing channels
Your new receiver is equipped with four ways to change channels.
Via direct access using the 0~9 buttons.
Via the channel list trough OK button.
Via the PG+ and PG- keys.
Via the pq keys.
6.1.1 Direct access via 0~9 buttons
To gain direct access to a certain channel, simply input its number with the 0~9
keys on the remote control. Channel numbers can be up to four digits long.
Entering a number with less than four digits is possible. Just wait a few seconds
and your receiver will switch to the selected channel or press OK immediately after
seleselecting the channel number.
To Next Page
Loading...
