P20
TROUBLESHOOTING
Select HDD Format from the Media+ menu and press OK to enter. Use tu to
select the partition you wish to format (Partition 1 is set per default) and press q
to highlight Format. Press OK to proceed, select FAT or Cancel, or press EXIT/
SORTIE to leave without formatting.
NOTE: It is possible to use already NTFS formatted USB disks.
7.6.5 DVR Configuration
This menu allows you to make settings for Time Shift and recording.
Select DVR Configuration from the Media+ menu and press OK to enter.
Use pq to move the highlight and tu to change settings.
Press EXIT/SORTIE to quit.
Time Shift: On or Off. When Time Shift is set to Off, Time Shift
becomes inactive.
Time Shift to Record: On or Off. When set to On, is Time Shift also
possible during record.
Record Type: TS or PS. When TS is selected, recordings will
also include subtitles and teletext (when available).
PS makes recordings without these extras.
Record Selection Select the partition the receiver will record on.
Standby after record: On or Off. Select if receiver must go to standby
mode after Timer record.
Step to (min): Defines the jump step length in playback mode.
Possible settings are 0.5/1/3/5/10 minutes.
8.0 TROUBLESHOOTING
There may be various reasons for abnormal operation of the receiver. Check the
receiver according to the procedures shown below. If the receiver does not work
properly after checking it, please contact your dealer or the local Service Hotline.
Do NOT try to open or disassemble the receiver. It may cause a dangerous
situation and warranty will
Problem Possible cause What to do
LED\Display not lit Mains lead unplugged Check mains plug
No signal found Aerial is disconnected
Aerial is damaged/
misaligned
Out of digital signal area
Active antenna requires
to switch ON antenna
power/external power
Check aerial lead
Check aerial
Check with dealer
Switch receiver’s Antenna
Power ON/connect
external power
To Next Page
Loading...
