P2
INTRODUCTION
1.0 INTRODUCTION
1.1 Safety Instructions
DO NOT INSTALL YOUR RECEIVER:
In a closed or poorly ventilated cabinet; directly on top of or under any other
equipment; on a surface which might obstruct the ventilation slots.
DO NOT EXPOSE THE RECEIVER OR ITS ACCESSORIES:
To direct sunlight or any other equipment that generates heat; to rain or intense
moisture; to intense vibration and to any shock which may cause permanent
damage to your receiver or to any magnetic objects, such as loudspeakers,
transformers, etc.
Do not use a damaged power cord. It may cause a fire or an electrical shock. Do
not touch a power cord with wet hands. It may cause an electric shock.
When the receiver is not used for a long period of time, you should unplug the
power cord from the wall socket.
Do not use alcohol or ammonia based liquids to clean the receiver. If you wish, you
may clean your receiver with a soft lint-free cloth slightly made damp with a mild
soap solution, only after disconnecting from the mains voltage supply. Make sure
no foreign objects fall through the ventilation slots because this could cause fire or
an electric shock.
Do not place any objects on top of the receiver because this might prevent proper
cooling of the components inside.
Safety Precautions
Never open the receiver cover. Doing so will void the warranty. It is dangerous to
touch the inside of the receiver due to high voltage currents and possible electrical
hazards. Refer all maintenance or servicing to qualified service personnel.
When you are connecting cables, be sure that the receiver is disconnected from
the mains supply. Wait a few seconds after switching off the receiver before you
move the receiver or disconnect any equipment.
Use only approved extension cords with compatible wiring that is suitable for the
electrical power consumption of the installed equipment. Please ensure that the
electrical power supply corresponds with the voltage on the electrical identification
plate at the back of the receiver.
If the receiver does not operate normally even after strictly following the instructions
in this user manual, it is recommended to consult your dealer.
1.2 Storage
Your receiver and its accessories are stored and delivered in a packaging designed
to protect against electric shocks and moisture. When unpacking it, make sure
that all the parts are included and keep the packaging away from children. For
transporting the receiver from one place to another or if you are returning it under
warranty conditions, make sure to repack the receiver in its original packaging with
its accessories. Failing to comply with such packaging procedures could void
your warranty.
To Next Page
Loading...
