MAIN MENU
P17
English
7.3.8 Auto Standby
Auto Standby is a new feature that helps you with reducing power consumption.
When set to On, the receiver will turn to standby if it doesn’t receive any commands
from the remote control for three hours. Set Auto Standby to Off to avoid the
automatic shut down.
7.4 Tools
Press MENU in viewing mode to enter the Main Menu.
Select the Tools submenu with pq and press OK or u to enter.
Use pq to highlight the desired submenu and press OK proceed.
Press EXIT/SORTIE to leave.
7.4.1 Receiver Information
This submenu shows receiver specific information such as hardware version and
software version. It also displays our web address www.thomsonstb.net. Please
have the Receiver Information screen on hand when you call our hotline. The
person who answers your call might ask for the information given in this screen.
7.4.2 Load Factory Setting
This option allows you to reset the receiver to factory settings, which clears all
stored channels.
WARNING! By resetting your receiver to factory default, all your settings and
stored channels will be permanently deleted. It will restore your
receiver to an “out of the box” state. Pl
Use pq to select “Load Factory Setting” in the Tools menu and press OK. You are
asked to input password.
Input the correct password using the 0~9 buttons (default: 0000). A confirmation
window is displayed.
Select Yes to return to factory settings. Then, proceed with chapter 4.
Select No if you don’t want to restore.
Press EXIT/SORTIE to leave.
7.4.3 S/W Upgrade by OTA
This receiver is equipped with an Over The Air software upgrade option. An Over
The Air update might not be available in your region. Please visit our website www.
thomsonstb.net or contact your local service hotline for more information about
this option.
7.4.4 Upgrade by USB
This feature allows you to upgrade your receiver’s software via the USB port. If new
software is available for your receiver, it can be downloaded from our website www.
thomsonstb.net.
Place the software file (unzipped) in the root directory of your USB storage device
(HDD, memory stick etc.) and insert this device into the USB port of the receiver.
Select Upgrade by USB from the Tools menu and press OK to proceed.
To Next Page
Loading...
