MAIN MENU
P13
English
confirmation window select Yes with tu and press OK to delete or select No
to cancel.
WARNING! The Delete all function will permanently delete all current channels and
all favourite lists from your receiver, and you are not able to leave the
menu until you search for channels again.
7.2 Installation
7.2.1 Auto Scan
Use pq to select Installation and press OK or u to advance.
Select Auto Scan with pq and press OK to enter.
Use tu to toggle between FTA Only Yes or No. When FTA Only is set to Yes,
scrambled channels won’t be stored in the channel list. Use pq to highlight
Search. Now press OK to start auto scan.
The receiver will store all newly found channels in the channel list.
7.2.2 Channel Scan
Use pq to select Installation, press OK or u to advance.
Use pq to select Channel Scan and press OK to enter.
Use tu to toggle between available scan modes: By Channel and
By Frequency.
If By Channel is selected, use the cursor buttons to select Scan Band and Channel
No. If By Frequency is selected, use the cursor buttons to select Frequency
and Bandwidth. Highlight Search and press OK to start scanning. Newly found
channels will be stored in the channel list.
7.2.3 Antenna Adjustment
Use pq to select Installation, press OK or u to advance.
Use pq to select Aerial Adjustment and press OK to enter.
Use pq move the highlight to the setting you wish to alter and use tu to
change values.
The following settings are available:
Antenna Power: Set to On if you use an active antenna. When set
to On, 5 V will be present on the ANT IN connector
of the receiver. Select Off for passive antennas.
Beeper: Select On for an audible indication of signal
reception. Off turns the beeper off.
Channel No.: Select a channel that is known to carry a
broadcast in your region. The Signal Strength and
Signal Quality bars give a visual indication of the
reception. Adjust your antenna to obtain maximum
signal strength and quality.
Press EXIT/SORTIE to leave the Antenna Adjustment screen.
To Next Page
Loading...
