YOUR RECEIVER
P3
English
1.3 Equipment Set-up
We recommend you consult a professional installer to set up your equipment.
Otherwise, please follow the instructions below:
Refer to the user manual of your TV and antenna.
Make sure that the HDMI cable and outdoor components are in a good condition.
Use only a HDMI 1.3 cable or higher for maximum performance.
If you use TV SCART connection, use then well shielded SCART cable.
This manual provides complete instructions for installing and using this receiver. The
following symbols will serve as follow.
WARNING Indicates warning information.
TIPS Indicates any other additional important or
helpful information.
MENU Represents a button on the remote control or the
receiver. (Bold Character)
Move to Represents a menu item within a window.
(Italic Character)
1.4 Accessories
1. User Manual
2. 1 Remote control unit
3. 2x Batteries (AAA type)
4. Infrared sensor
NOTE: The batteries should not be recharged, disassembled, electrically
short-circuited, be mixed or used with other types of batteries.
1.5 Usage of external USB devices
It is recommended to use USB 2.0 storage devices or higher. If your device is not
compatible to USB 2.0 specifications, recording, playback and other multimedia
functions of the receiver might not work properly.
To ensure best performance of your USB storage device please format it by this
receiver (menu “Media+”) to FAT32 system. Other file systems are not supported
by the receiver. However, it is possible to use already NTFS formatted disks.
THOMSON cannot guarantee compatibility with all types of USB storage devices.
It is advised not to store important information on USB storage devices used with
the receiver. Always make backups of data on your USB storage device before
using it with this receiver. THOMSON will not take responsibility for any loss of
information or circumstances caused by loss of information.
2.0 YOUR RECEIVER
2.1 PIN-CODE DEFAULT: 0000
2.2 Front Panel
Fig. 1
To Next Page
Loading...
