P18
MAIN MENU
The upgrade menu will now be displayed.
Use pq to select Upgrade Mode and choose option Allcode.
Use pq to select Upgrade File and choose the file containing the new software.
Once all settings are made, move the highlight to Start and press OK to start the
upgrade process.
After a few seconds, the receiver asks: “Are you sure to burn flash?”. Select
Yes to finalize the upgrade or No to quit
without upgrading.
WARNING! After an update the receiver restarts automatically. During the
upgrade process NEVER disconnect the receiver from the mains or
switch off the power! Doing so might damage your receiver and will
void warranty!
NOTE: If, after a software upgrade, the receiver should behave in an
unexpected way, please perform a factory reset as well. See
chapter 7.4.2.
7.4.5 Remove USB device safely
Select Remove USB device safely from the tools menu and press OK. The receiver
will display a message indicating that you can safely remove your storage device
from the receiver.
NOTE: After performing this function, the USB device is no longer
accessible from your receiver. To gain access to your storage device
again, re insert it or switch the receiver to standby and on again.
7.5 Games
Your receiver is equipped with two games which can be played on your TV screen
using the receiver remote control.
Use pq to select Game from the Main menu and press OK or u to proceed.
Select one of the available games (Othello or Sudoku) using pq and press OK to
start the game. Follow the directions on screen.
Use EXIT/SORTIE to quit a game.
7.6 Media+
The Media+ menu consists of the following submenus: Media Player, Record
Manager, DVR HDD Information, HDD Format and DVR Configuration.
Use pq to highlight the desired menu and press OK to enter.
Press EXIT/SORTIE to quit.
7.6.1 Media Player
This function allows you to play MPEG, AVI, MP3, JPG many other type files from
connected storage device (see details in technical part).
Select Media Player from the Media+ menu and press OK to proceed.
To Next Page
Loading...
