TECHNICAL SPECIFICATIONS
P21
English
Problem Possible cause What to do
No picture or
sound on TV
HDMI is not selected on
your TV or Amplifier or is
set to higher resolution as
TV supports
TV is not switched on
Switch to correct TV input
Select lower resolution on
receiver
Switch TV on
Scrambled channel
Message
Channel is scrambled Select alternative channel
No response to
remote
control
Receiver off
Remote not aimed
correctly
Front panel obstructed
Remote batteries
exhausted
Plug in and turn on plug
Aim remote at front panel
Check for obstructions
Replace remote batteries
Forgotten PIN code Default PIN is 0000
Contact local Service
Hotline or send email to
our Support via www.
thomsonstb.net
After moving the
receiver to another
room/area you
are no longer able
to receive digital
reception
Antenna signals are too
weak
Press the: INFO button on
remote 3x to call up signal
bars and adjust antenna
for (maximum) reception
or rescan channels
The receiver
switches off
automatically.
Auto Standby function
enabled.
Disable auto standby. See
section 7.3.8 for details.
9.0 TECHNICAL SPECIFICATIONS
Demodulator
Demodulator: COFDM; 16 QAM/64 QAM, QPSK
Transmission mode: 2 K - 8 K
Video
Profile level: MPEG-2 MP@ML, AVC/H264HP@L4.1, MPEG4
ASP supported
Video resolutions: 576i/576P/720P/1080i/1080P
Decoding & Video out: PAL
Aspect ratio: 4:3 Letterbox, 4:3 Pan & Scan, 16:9, Auto
Audio Decoder
Audio support: AAC/DD+*/AC3/PCM
To Next Page
Loading...
