P16
MAIN MENU
Timer Service: Choose between Channel (Timer will wake up the
receiver) or Record (Timer will start to record the
scheduled event).
Wakeup Channel: Use tu to select the channel the timer will wake
up with.
Wakeup Date: Use the 0~9 buttons to input the date for the
timed event.
Wakeup Time: Use the 0~9 buttons to input the desired start time.
Duration: Use the 0~9 buttons to input the timer duration.
Once all settings are according to your wishes, use pq to move the highlight to
Save and press OK to confirm. To quit the timer without saving your settings, move
the highlight to Cancel.
7.3.5 Parental Lock
This menu allows you to protect the installation menu and/or channels with a
password. You can also enter a new password in the Parental Lock menu.
Use pq to select Parental Lock from the System Setup menu and press OK to
proceed. You will be asked to enter your pin code. (DEFAULT: 0000)
Menu Lock: Locks the installation menu. You can set Menu
Lock to On or Off.
Channel Lock: Choose between: Off, AGE 4, AGE 5, up to AGE
18. Channels with a parental rating above the
chosen age will be protected with a password (if
available in your local broadcast.)
New Password: Enter your new password (4 digits) here.
Confirm Password: Re-enter your password here to confirm.
7.3.6 OSD Setting
This menu allows you to change settings for: OSD Timeout and OSD Transparency.
OSD timeout: Sets the time after which on screen banners and
messages disappear. The range is 1~10 seconds.
OSD Transparency: To set the OSD transparency from Off ~ 40% with
10% steps.
Load Default OSD Setting: Press OK to clear all OSD settings and reset to
default values.
7.3.7 Favourite
This menu allows you to personalize the names of the 8 available favourite lists.
Use pq to select Favourite from the System Setup Menu and press OK to
proceed. The names of all groups are now displayed. Select the desired favourite
group with pq and press OK to edit its name. A text field will now pop up at the
right of the screen. Use tu pq to select the desired characters and enter them
with OK. Once you have finished editing, press BLUE to save the changes. Once
all changes are made, press EXIT/SORTIE twice.
To Next Page
Loading...
