THOMSON TR-069 - VLAN Provisioning (Layer2 Bridging)

E-DOC-CTC-20071119-0003 v1.0
97
6| Service Provisioning
6.12 VLAN Provisioning (Layer2Bridging)
Layer2Bridging data model
The IGD data model contains the object “InternetGatewayDevice.Layer2Bridging.”.
This object supports VLAN provisioning, which allows to:
 Create and configure new VLANs
 Configure port VLAN membership
 Configure default port VID
 Configure egress VLAN tagging
Vendor specific parameters
The Layer2Bridging data model on the Thomson Gateway contains no vendor specific parameters.
Message flow
Following illustration shows a possible message flow for VLAN provisioning:
ACSCPE
Transaction session
Obtain Bridge and Interface Information
7) GetParameterValues
8) GetParameterValuesResponse
...
5) Apply changes
Configure the VLAN
4) SetParameterValues
6) SetParameterValuesResponse
Create a VLAN
1) AddObject
3) AddObjectResponse
2) Apply changes
Create a Filter
9) AddObject
11) AddObjectResponse
10) Apply changes
13) Apply changes
Configure Port VLAN Membership
12) SetParameterValues
14) SetParameterValuesResponse
16) Apply changes
Configure default Port VID
15) SetParameterValues
17) SetParameterValuesResponse
...
Create a Marking
18) AddObject
20) AddObjectResponse
19) Apply changes
22) Apply changes
Configure Egress VLAN Tagging
21) SetParameterValues
23) SetParameterValuesResponse