THOMSON TR-069 - WAN PPP or IP Connection Setup

E-DOC-CTC-20071119-0003 v1.0
62
5| WAN Connections
5.2 WAN PPP or IP Connection
Introduction
Before, configuring your WAN PPP or IP connection, make sure that you created and configured a WAN
connection device. For more information, see “5.1 WAN Connection Device” on page 61.
WAN PPPoE connection
A WAN PPPoE connection can be created and configured as follows:
 Creating a PPPoE connection: the AddObject RPC (message 7 in preceding illustration) contains for the
ObjectName argument the value
“InternetGatewayDevice.WANDevice.1.WANConnectionDevice.2.WANPPPConnection.”.
The AddObjectResponse (message 9 in preceding illustration) contains for the InstanceNumber
argument for example value “1“.
 Configuring the PPPoE connection: the SetParameterValues RPC (message 10 in preceding illustration)
contains following name-value pairs in its ParameterList argument:
WAN PPPoA connection
A WAN PPPoA connection can be created and configured as follows:
 Creating a PPPoA connection: the AddObject RPC (message 7 in preceding illustration) contains for the
ObjectName argument the value
“InternetGatewayDevice.WANDevice.1.WANConnectionDevice.2.WANPPPConnection.”.
The AddObjectResponse (message 9 in preceding illustration) contains for the InstanceNumber
argument for example value “1“.
Name Value
InternetGatewayDevice.WANDevice.1.WANConnectionDevice.2.
WANPPPConnection.1.NATEnabled
1
InternetGatewayDevice.WANDevice.1.WANConnectionDevice.2.
WANPPPConnection.1.Username
<username>
InternetGatewayDevice.WANDevice.1.WANConnectionDevice.2.
WANPPPConnection.1.Password
<password>
InternetGatewayDevice.WANDevice.1.WANConnectionDevice.2.
WANPPPConnection.1.Name
Internet
InternetGatewayDevice.WANDevice.1.WANConnectionDevice.2.
WANPPPConnection.1.Enable
1
The parameter Name is mandatory. This means that the parameter must be set before the
WANPPPConnection object is internally created.