THOMSON TR-069 - Runtime Variables

E-DOC-CTC-20071119-0003 v1.0
26
2| Configuring CWM
P on the Thomson Gatew
ay
2.2.5 Runtime Variables
Listing runtime variables
The values of the runtime variables cannot be changed and can only be listed.
To list the CWMP runtime variables, execute following command:
Software Version
This variable indicates which firmware image is installed on the CPE. It has the value of the
InternetGatewayDevice.DeviceInfo.SoftwareVersion parameter.
The CPE sends the value of this variable to the ACS in the ParameterList argument of Inform RPCs.
Bootstrapped
This variable indicates the BOOTSTRAP event state.
If this event state is set to
yes, the first Inform RPC sent to the ACS includes the Bootstrap event. On
receiving an InformResponse, this event is considered delivered and the event state is set to no.
This variable is set to
yes if the ACS URL is reconfigured.
CmdKey
CmdKey has the value of the CommandKey argument of a received Reboot, Download or ScheduleInform
RPC. The CPE stores the value persistently and sends this value back to the ACS as follows:
 Reboot: the value of CmdKey is used as CommandKey for the “M Reboot” EventCode in the first Inform
RPC sent after the reboot.
 Download: the value of CmdKey is used as CommandKey for the TransferComplete RPC or
GetQueuedTransfersResponse RPC.
 ScheduleInform: the value of CmdKey is used as CommandKey for the “M ScheduleInform” EventCode
in the Inform RPC sent at the scheduled time.
Parameterkey
Parameterkey has the same value as the InternetGatewayDevice.ManagementServer.ParameterKey
parameter.
Following RPCs contain a ParameterKey argument:
 SetParameterValues
 AddObject
 DeleteObject
If one of these RPCs is applied successfully, the CPE updates the value of the
InternetGatewayDevice.ManagementServer.ParameterKey parameter with the value of the ParameterKey
argument.
=>:cwmp runtimevar
Software Version : 7.4.2.2
Bootstrapped : no
CmdKey :
Parameterkey :