E-DOC-CTC-20071119-0003 v1.0
13
2| Configuring CWMP on the Thomson Gateway
2 Configuring CWMP on the Thomson Gateway
Introduction
This chapter describes in detail the configuration of CWMP on the Thomson Gateway using CLI commands.
This includes the configuration of the TLS/SSL client and certificates, the CWMP service manager and
daemon, and the state checks to detect service activity.
Overview
This chapter is structured as follows:
CWMP is not configurable via the GUI (Graphical User Interface).
Topic Page
“2.1 Configuring TLS” 14
“2.2 Configuring CWMP” 18
“2.3 Configuring State Checks” 28
To Next Page
Loading...
