E-DOC-CTC-20071119-0003 v1.0
18
2| Configuring CWM
P on the Thomson Gatew
ay
2.2 Configuring CWMP
Introduction
The implementation of CWMP on the Thomson Gateway is split up in two parts:
CWMP service manager: use the service manager to:
Enable or disable the CWMP client.
Assign a specific QoS label and route label to traffic originated by the CWMP client.
Enable or disable the CWMP connection request server.
Configure the port used by the CWMP connection request server to receive connection requests.
Enable or disable logging of the CWMP connection request server.
Configure the NAT portmap weight of the CWMP connection request server.
CWMP daemon: use the daemon to configure all other aspects of the CWMP protocol, including:
Operational mode.
Use of Periodic Inform RPCs.
Use of Connection Requests.
Session termination.
Authentication user names and passwords.
Overview
This section is structured as follows:
Topic Page
“2.2.1 CWMP Service Manager” 19
“2.2.2 CWMP Daemon as seen from the ACS” 21
“2.2.3 CWMP Daemon towards the ACS” 24
“2.2.4 Notification Rules” 25
“2.2.5 Runtime Variables” 26
To Next Page
Loading...
