E-DOC-CTC-20071119-0003 v1.0
17
2| Configuring CWMP on the Thomson Gateway
Listing ACS certificate information
The Thomson Gateway uses pre-provisioned certificates for server authentication.
To list the pre-provisioned certificates on the Thomson Gateway, execute the command
:tls acs-
client cert list
.
Optionally, two parameters can be specified:
Index: if this parameter is used, the displayed list is restricted to the certificate with the corresponding
certificate index.
Expand: if this parameter is enabled, more information is displayed. A base64 dump of each displayed
certificate is shown.
Pre-provisioning ACS certificates
The Thomson Gateway can receive the pre-provisioned certificates for server authentication as follows:
File upload: through file upload (using FTP or TR-069).
Proceed as follows when using FTP:
1 Set up an FTP session from your PC to the Thomson Gateway.
2 Go to the /dl directory with the command
cd /dl.
3 Put the certificate on the Thomson Gateway. The command
put <filename> transfers the file
with name <filename> from the PC directory C:\Documents and Settings\<Username>\ to the
Thomson Gateway directory /dl.
4 Close the FTP session with the command
bye.
Customization: usually, the Thomson Gateway is pre-provisioned with the correct ACS certificates using
a customized build. The process of embedding the correct certificates in a software build is executed by
Thomson during customization, prior to delivery.
Currently, these certificates are not customizable using the customization wizard, but must be added
manually to the software build by Thomson.
Configuring the list of trusted ACS certificates
To add a certificate to the list of trusted certificates, execute following command:
To delete a certificate from the list of trusted certificates:
=>:tls acs-client cert list expand=enabled
=>:tls acs-client cert add filename=<filename>
=>:tls acs-client cert delete index=<filename>
To Next Page
Loading...
