THOMSON TR-069 - TLS Client

E-DOC-CTC-20071119-0003 v1.0
15
2| Configuring CWMP on the Thomson Gateway
2.1.1 TLS Client
Displaying the TLS client configuration
To display the configuration of the TLS client, execute following command:
Configuring the TLS client
To configure the TLS client, execute the command :tls acs-client config and specify one or more of
following parameters:
 State: this parameter indicates the state of the TLS client. By default, the TLS client is enabled.
 Auth-serv: if this parameter is enabled, the TLS client (Thomson Gateway) requests authentication of the
TLS server (ACS). By default, this parameter is enabled.
 Valid-date: if this parameter is enabled, the TLS client checks the validity of the date of a received
certificate.
 Valid-domain: if this parameter is enabled, the TLS client checks the domain of a received certificate.
For example, configure the TLS client as follows:
=>:tls acs-client config
SSL/TLS client for ACS state : enabled
Request server authentication : enabled
Check certificate validity date : disabled
Check certificate domain : disabled
=>:tls acs-client config state=enabled auth-serv=enabled valid-date=enabled
valid-domain=enabled