E-DOC-CTC-20071119-0003 v1.0
9
1| Introduction
4 File transfer is initiated: a HTTP GET message is sent by the CPE to the file server.
5 File transfer is completed (or an error occurred).
6 A new transaction session to send the TransferComplete RPC is established after loading the downloaded
configuration file or firmware image. The exact steps depend on the FileType argument of the Download
RPC. For more information, see “3.1 Firmware Upgrade” on page 32 and “3.2 Configuration Update” on
page 41.
The Download RPC can also be triggered from the CLI. To this end, use the CLI command
:software download and provide the requested Download RPC parameters (filetype, url,
username, password, filesize, targetfilename).
To Next Page
Loading...
