THOMSON TR-069 - Page 26

E-DOC-CTC-20071119-0003 v1.0
20
2| Configuring CWM
P on the Thomson Gatew
ay
CWMP connection request server
To display the default attribute values of the CWMP connection request server service, execute following
command:
You can configure the value of following attributes:
 State: by default, the CWMP connection request server service is disabled.
To enable the service, execute following command:
 Port: this attribute is the port on which the connection request server listens for connection requests. The
default port is 51005.
To assign another port number to the port, execute following command:
 Log: this attribute is used to enable or disable service logging in the syslog message buffer. By default,
logging is disabled.
To enable logging of the service, execute following command:
 Natpmweight: the NAT portmap weight for the service. By default, this attribute has value 30.
To change the value of this attribute, execute following command:
=>:service system list name=CWMP-S expand=enabled
Idx Name Protocol SrcPort DstPort Group
---------------------------------------------------------------------------------
1 CWMP-S tcp 51005
Description................ CPE Wan Management Protocol Server
Properties................. server
Attributes................. state port aclip aclif aclifgroup map log qoslabel
routelabel natpmweight
User Managed Attributes..... state port log natpmweight
Attribute Values :
State...................... (administratively) disabled
Port....................... 51005
QOS Label.................. None
Route Label................ None
NAT Portmap Weight ........ 30
Ip Access List............. any
Interface Access List...... any
Interface Group Access List any
Map List................... 51005
Logging.................... disabled
=>:service system modify name=CWMP-S state=enabled
=>:service system modify name=CWMP-S port=51006
=>:service system modify name=CWMP-S log=enabled
=>:service system modify name=CWMP-S natpmweight=30