TAP and TS4 MLPE – Install TS4 MLPE
EI Residential Solar Solution US Installation Manual | www.tigoenergy.com | Help Center 51
2. Remove the barcode sticker on the TS4 and place it on the PV array map located at the
end of the EI Inverter Quick Start Guide. Ensure the sticker matches the physical
location of the module on the roof.
3. Connect the longer set of TS4 output cables to the neighboring TS4 to create a string.
4. For installation data specific to your TS4 (TS4-A-O/S/M), visit the Tigo Downloads page:
To Next Page
