Toa D-901 - Page 19

19
NOM Attenuation ON/OFF Settings
(p. 39)
Input Channel Group Trim Gain
Settings
(p. 40)
Auto-Mixing Group Settings
(p. 37)
Input Channel Gain Settings
(p. 40)
(Only when Group is set)
Priority Settings
Attenuation settings
Attack time settings
Release time settings
Ducker settings (p. 38)
(From the previous page) (From the previous page)
(To next page)
Hysteresis settings
Depth settings
Hold time settings
Attack time settings
Release time settings
Threshold Level Settings
Gate settings (p. 35)
1 2
3
Attack Time Settings
Release time settings
Level sense settings (p. 34)
Bus Assignment Settings
Crosspoint gain settings
Bus assignment and crosspoint gain settings (p. 41)
Threshold Level Settings
Ratio settings
Attack time settings
Release time settings
Makeup gain settings
(Compressor mode)
Compressor settings (p. 31)
Target Level Settings
Maximum gain settings
Attack time settings
Release time settings
(Auto-leveler mode)
Auto-leveler settings (p. 33)
Compressor/Auto-Leveler Mode
Selection
(p. 31)