8
• Universal terminal: Controls whether the UT server is actively
receiving connections from other devices.
This may be useful if there are multiple UTs on the bus and
multiple UTs claim to be the primary UT (in which case the UT
will go offline automatically and require the UT Number to be
changed before it will go online again), or to temporarily
deactivate the UT on the console.
• UT number: Sets the UT number for the console. If there are
multiple UTs on the bus, use this setting to assign a unique
number to this UT to avoid conflicts. The UT with number 1 will
be the default UT. If the UT client doesn’t appear on the correct
UT you may need to reconfigure its UT number appropriately. If
there is a conflict, the following message will appear:
'The UT Number of this UT conflicts with another UT on the bus,
and this UT has been disabled. Please make sure that this UT has
a unique UT Number.'
• Soft keys per column: Sets the number of available softkeys on
the UT interface on the Operation screen. Note: This should be
set to 6.
• Soft key location: Sets the location of the softkeys on the UT
interface and the number of columns (1 or 2).
To Next Page
Loading...