Chapter 7 – UT Screens
43
7.6. Set tare screen
It is good practice to set tare at least once a day, or more often if
harvesting oily or dirty crops. This informs the system of the height of
each empty paddle in the clean grain elevator. While harvesting, this
tare value is removed from each paddle reading so that just grain is
being measured.
1. Ensure the harvester is on level ground.
2. With the grain elevator empty, run the harvester at normal
threshing speed.
3. Press . Figures are automatically adjusted.
Tare = unladen weight. Setting the tare is the same as zeroing scales.
Icon Description
Percentage of darkness when machine is not harvesting
(empty paddles on grain elevator)
Shows percentage of darkness being measured by optical
sensors on clean grain elevator
The chain speed, should be constant. This shows how fast
the elevator is rotating.
To Next Page
Loading...