16
Measurements used are as follows:
• Swath Width: Measures the working width of the implement
(that is, the width of the area that is treated during one pass of the
implement).
• Working Length: Length from the start to the finish of the
working area of the boom. Together with swath width, it defines
the ‘Working Area’, which is the region that product is applied
over for that boom.
• Overlap: Measures the width of the overlap between two
adjacent passes.
• Implement Offset: Measures the distance between the hitch point
and the wheels of the implement.
• Implement Wheels Offset: Measures the distance between the
wheels and the working area of the implement.
• Inline Offset: Measures the off-center offset of the implement
relative to the hitch point. Enter a positive number if the
implement is shifted to the right and a negative number if it is
shifted to the left.
• Trailer Offset: Measures the distance between the trailer hitch
point and the trailer wheels.
• Trailer Wheels Offset: Measures the distance between the
implement hitch point and the trailer wheels.
To Next Page
Loading...