Topcom YieldTrakk YM-1 - Page 48

32
Step When / why? How?
Test moisture
percentage and adjust
At regular intervals
throughout the day.
Adjustment is needed
if the harvest moisture
reading is different
from that of a
reference moisture
meter.
See Crop settings
screen, page 38.
Test crop density and
adjust (kg/hl)
At regular intervals
throughout the day.
An incorrect density
setting is one of the
most likely causes of
inaccurate yield data.
A grain weight tester
is supplied with the
system. This is used
to determine the value
to enter on the Main
screen, see page 35.
Compare actual
weight with
calculated weight
Adjustment may be
required if
YieldTrakk provides
consistent
discrepancies between
its yield readings and
the weighbridge
readings.
Note: Always check
moisture % and crop
density before
adjusting Crop Cal.
Factor.
See Crop settings
screen, page 38.